MicroNet™ Control Service Packs

9927-2763_-.exe

This Service Pack (9927-2763) is for the MicroNet CPU P1020 VxWorks control. The Service Pack will upgrade any MP1020 cpu running 5418-7033 footprint to 5418-7799 Revision New (-).

This release is done mainly to update the vxWorks kernel version to 6.9.4.11 and address the urgent/11 vxWorks vulnerabilities released by windriver in july of 2019. See link to vxWorks security bulletin for more details. Apart from that this release also addresses issues and new feature requests as reported through woodward knowledge base. See Micronet 1.02-0 Release notes (9927-2801Rev-) to get to get a list of all the issues/features this release contains

COMPATIBILITY: You will need Micronet 1.02-0 or higher Coder oto run this footprint. You can use 9927-2800 Rev- installer to install this coder

COMPATIBILITY: You will need AppManager 3.14 or higher to install this servicepack

 

System Requirements:

System Requirements:

• GAP 4.02 or higher
• AppManager 3.14 or higher
• Control Assistant 4.1 or later
• Pentium® PC
• 32 MB of RAM
• Windows® 2000, XP, Vista, 7 or greater
  

Installation Instructions:

After downloading this file, you will install this service pack using AppManager from your desktop or laptop computer. For instructions on installing the service pack, refer to the AppManager help. AppManager Help is started under the Help menu.

Running the Service Pack:  The service pack installs the new firmware on the CPU. This takes approximately 9 minutes. DO NOT REBOOT OR POWER DOWN THE CPU DURING THIS PROCESS!  AppManager will prompt to reboot the CPU. Once the CPU is rebooted, the CPU will begin to install the new files.  The Status LED will flash green and yellow during this process.  The CPU will reboot on its own after this process has completed and the CPU will be visible with AppManager. The entire process takes approximately 15 minutes.